 |
ICP Solar 21000 SolarPRO Plug'n'Play 100-Watt Kit by ICP Solar
Product DetailsManufacturer: ICP Solar Model: 21000 Product features: - Great for travelers and vacationers alike, these solar panels provide supplemental power to RV, marine or cabin batteries
- 100 watts of power
- Clean, quiet, dependable; completely weather resistant panel
- Expand your system as your needs grow
- Integrated LED power indicator on every solar panel
Accessories:
Tools and Hardware Reviews of ICP Solar 21000 SolarPRO Plug'n'Play 100-Watt KitCustomer Review: ICP Global 100 Watt Plug & Play Solar Kit - Recommended Summary: 4 StarsThis kit came with the 21 amp controller, rather than with the 7 amp controller as expected. (Nice surprise!) See separate review for the 21 amp controller. This is a Plug and play installation as advertised, and appears to be working well. The kit comes complete with stainless mounting brackets, stainless mounting screws, controller, and connecting wire.Strong points: Extremely good technical support. Easily installed for the most part. Quite well made. Even includes a cable to allow connection to another similar pannel. Up to 300 watts can be connected together, as the pannel has two connections, to allow tying to another pannel or/and to the battery/controller. Mounting is simple using the supplied brackets. Nice design. The controller is necessary only if you have a amperage charge capacity of greater than 1.5% of the battery's amp hour rating At near full battery charge, the cell was outputting about 50% rated power under a noon sun. Weak points: The cables supplied are number 12 wire, which is adequate for the lengths of wire supplied, but heavier wire is recommended for longer runs. I wound up using #6 wire per their recommendations, but had to connect to the pannel using the supplied #12 wire, as it has the required their molded connectors. The solar pannel itself is supposed to be sealed from weather. There is a rubber/plastic bead seal that runs around the inside edge of the solar cell frame, similar to an aluminum storm window. This bead was cut at each of the 4 corners, and because I was afraid it would shrink over time, I covered the corners with RTV. When laying flat, the panel lies about 3/32" recessed in the frame. I have a concern about water collecting on the face of the solar cell, then leaking onto the cell. Note that they guarantee the cell to produce 80% of original power for life of ownership. It has been installed about a week.
Lawn & Landscaping
|
 |